PCchairs: Task Series
OWNERS MANUAL:
TASK SERIES

Assembling a chair from PCchairs is very easy, so easy that no tools are required. Assembly of a PCchair at home is typically completed in 3-4 minutes.

To Assemble Your PCchairs:

  • Remove all contents from the carton. You should have a backrest assembly, and a seat & base assembly. Armrests, if ordered, are also packaged in this box.
  • Loosen the backrest handwheel near the back of the seat.
  • Remove the black plastic button from the hole on the lower part of the backrest support bar.
  • Slide the support bar through the slot, next to handwheel, making sure the bar comes out at the bottom. Tighten the handwheel securely.
  • Push the black plastic button back into the small hole near the bottom of the back support bar.

To Install Optional Armrests:

  • Remove the two handwheels with washers located under the seat on the armrest brackets. Be sure to keep the lock washer closest to the handwheel and the plain washer on top of that.
  • Slide the armrest assemblies into the armrest brackets with the wider part of the arm pad facing towards the front of the seat and the arms spaced equally from the seat on both sides.
  • Reinstall the handwheels with washers and tighten.

Chair Operating Instructions

  • Pneumatic Seat Height Adjustment: to raise seat, lift weight off chair and lift lever (1). To lower seat, lift lever (1) while seated.
  • Seat Tilt Adjustment: While seated, lift paddle (2). Set seat at desired angle, then release lever.
  • Backrest Angle Adjustment: While seated, lift paddle (3). Set backrest at desired angle, then release lever. Backrest Height Adjustment: (Positions built in lumbar support to individual height.) Loosen handwheel (4), raise or lower backrest to desired height, then tighten handwheel.
  • Optional Armrests (A1 or A2) : Width Adjustment - loosen handwheels under the seat. Set arms to desired width and tighten. Height Adjustment – Turn knobs on the side of the arms clock-wise to raise, counter-clockwise to lower, or while the knobs are in the upright position, pull back on them to slide arms up or down.

Optional Swivel Arms (A2) also adjust two positions inward for keyboarding and two positions outward for "mousing" or surfing.