OWNERS MANUAL:
S10 ECONOMY SERIES |
|
Assembling
a chair from PCchairs is very easy, so easy that no tools are required.
Assembly of a PCchair at home is typically completed in 3-4 minutes.
To Assemble Your
PCchair:
- Remove all contents
from the carton. You should have a backrest assembly, and seat & base
assembly.
- Remove the control
unit handwheel underneath the back of the seat. Slide the backrest support
bar through the smaller slot under the seat.
- Re-install the
handwheel
- Position backrest
at the distance you want it from the seat.
- Tighten the control
unit handwheel securely. (Periodically, check to make certain this handwheel
is tightened securely).
Chair Operating
Instructions
- Pneumatic Seat
Height Adjustment:
to raise seat, lift weight off chair and lift lever. To lower seat,
lift lever while seated.
- Backrest Height
Adjustment: (Positions the built-in lumbar support to individual
height.) Loosen handwheel on the back of the chair. Raise or lower backrest
to desired height, then tighten the handwheel.
- Backrest Depth
Adjustment:
(Positions the backrest closer to or farther away from chair seat.)
Loosen the control unit handwheel under the back of the seat, move backrest
in or out to desired distance from the seat, then tighten handwheel.
|
