OWNERS MANUAL: MANAGERIAL SERIES

Assembling a chair from PCchairs is very easy, so easy that no tools are required. Assembly of a PCchair at home is typically completed in 3-4 minutes.

To Assemble Your PCchair:

• Remove all contents from the carton. You should have a backrest assembly, and a seat & base assembly. Armrests, if ordered, are also packaged in this box.
• Loosen the backrest handwheel near the back of the seat.
• Remove the black plastic button from the hole on the lower part of the backrest assembly support bar.
• Slide the backrest assembly support bar through the slot, next to handwheel, making sure the bar comes out at the bottom.
• Tighten the handwheel securely.
• Push the black plastic button into the small hole near the bottom of the back support bar.

To Install Optional Armrests:

• Remove the two handwheels with washers located under the seat on the armrest brackets. Be sure to keep the lock washer closest to the handwheel and the plain washer on top of that.
• Slide the armrest assemblies into the armrest brackets with the wider part of the arm pad facing towards the front of the seat and the arms spaced equally from the seat on both sides.
• Reinstall the handwheels with washers and tighten.

Chair Operating Instructions

1. Pneumatic Seat Height Adjustment: To raise seat, lift weight off chair and lift lever (1). To lower seat, lift lever (1) while seated.
2. Backrest Angle Adjustment: While seated, lift paddle (2). Set backrest to desired angle, then release lever. Backrest Height Adjustment: (Positions built in lumbar support to individual height) Loosen handwheel (3), raise or lower to desired height, tighten handwheel.
3. Free Float Rocking Motion: (For Continuous Lumbar Support) To activate, lift and set paddle (4) to upper setting. To lock in a desired seat & backrest angle, set paddle to lower setting.
4. Rocking Tension Adjustment: While seated, turn handwheel (5) in a clock-wise direction to increase tension, counter clock-wise to decrease tension.
5. Forward Tilt Angle Control: For maximum support when using your keyboard, activate the Free Float Rocking Motion (4-Upper). Lean back a bit. Pull lever (6) down and towards the backrest. To limit the forward tilt angle, lean back, position lever (6) forward and up.
6. Optional Armrests: Width Adjustment - loosen handwheels under the seat. Set arms to desired width and tighten. Height Adjustment – Turn knobs on the side of the arms clockwise to raise, counter-clockwise to lower, or while the knobs are in the upright position, pull back on them to slide arms up or down. Swivel Arms also adjust two positions inward for keyboarding and two positions outward for "mousing" or surfing.